The follow-up to the successful NEBOX is here, introducing the Kangertech CUPTI Starter Kit. This starter kit is another all-in-one device, similar to the NEBOX, but Kanger took all of the feedback from the original, made some improvements, and then released this new CUPTI. The CUPTI has the same form factor as the original, but the size has been reduced by a good amount. One of the main problems a lot of NEBOX users had was constant leaking, due to the bottom airflow mechanism. The new CUPTI addressed this problem by moving the airflow control to the top of the mod, rather than the bottom. Not only is the leaking problem fixed, this new all-in-one mod also now has airflow control, and can be controlled with a simple turn of the airflow control valve.
The new CUPTI by KangerTech has a 5ml e-liquid capacity and can be quickly filled by removing the top airflow chamber. Another improvement over the original is that the CUPTI uses a replaceable glass tank and can be easily replaced if it breaks from being dropped. The CUPTI uses a single replaceable 18650 battery (sold separately) and it can be charged via the micro USB port with the included USB cable, or can be quickly swapped out via the bottom battery cover for a fully charged 18650 battery.
The CUPTI allows you to inhale Mouth-To-Lung (MTL) or Direct Lung (DL) as Kangertech has made MTL coils for this mod as well as DL coils. Not only is there different coil options, there is also an optional Rebuildable Atomizer (RBA) deck (sold separately) allowing you to build your own coils. The CUPTI has an increased 15 watts over the original NEBOX, with a total of up to 75 watts, and also has temperature control up to 300°C with modes for Ni200, Titanium, Stainless Steel, and Nichrome wire. The OLED display allows you to easily see and adjust all your settings with the + and – buttons, coil resistance and also shows current battery life.
Specs & Features:
- All-In-One Design
- Designed For Both Mouth-To-Lung (MTL) And Direct Lung (DL) Vapers
- Temperature Control For:
- Nickel 200
- Stainless Steel
- Temp. Control Resistance Range: 0.15Ω – 1.3Ω
- 5.0ml Tank Capacity
- Operating Wattage: 7.0 – 75.0W
- Temperature Range: 100°C – 300°C (200°F – 600°F)
- Top Adjustable Airflow Control Valve
- Leak Resistant Cup Design
- OLED Display Screen
- Durable Surface Finish
- Zinc And Aluminum Alloy Construction
- 510 Drip Tip Compatible
- Micro USB Charging Port
- Utilises 1x High Amp 18650 Battery (Sold Separately)
- Utilises Kanger CLOCC Atomizer Heads
- Supports The Optional CLRBA Rebuildable Atomizer Deck (Sold Separately)
- 60mm x 102mm x 22mm
- 1 x Kangertech CUPTI
- 1 x 0.5Ω CLOCC SUS316L Coil For DL (Pre-Installed)
- 1 x 1.5Ω CLOCC NiCr Coil For MTL
- 1 x Smaller Drip Tip Mouthpiece
- 1 x USB Cable
- Battery Stickers
- Manual And Authenticity Check Instruction Card
NOTE: Descriptions, specifications, and claims are based on manufacturer information. Information listed and provided are to be used at the sole discretion of the consumer.